If the plate comes in contact to the end mill, then the circuit is closed and mach3 will sense an active low on the input pin.Ĭlick the link to add information to this solution: Mach3 USB interface board. If your probe is used as a Z-Axis zero plate, then the concept is the same, but the end mill is connected to V- and the plate is connected to the input pin. When Mach3 senses an active low on the input pin, mach3 knows that the probe has made contact (closed the circuit). The way the probe works is when the probe is in contact with an object, a specific spring mechanism will cause the input pin to be connected to the V- (close the circuit). Please make sure that you have 24V connected to the V- and V+ on that side of the Mach3 USB board. Mach3 Setup & Configuration Mach3 is the most popular CNC control. One of those two wires will need to be connect to an input pin as shown in this wiring diagram (the diagram show the probe connected to pin I4): The other pin is connected to V-. Mach3 works on most Windows PC/Laptops to control the motion of motors (stepper. Depending on the probe that you have, you should have two wires coming from the probe.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |